[DeTomaso] Coolant drain
MikeLDrew at aol.com
MikeLDrew at aol.com
Mon Sep 10 20:48:03 EDT 2012
In a message dated 9/10/12 17 25 33, fisher95020 at yahoo.com writes:
> Any better ideas?
>
>>>Lots. :>)
First of all, the standard drain petcock leads to water going all over the
place as you have experienced. But it's a very simple matter to replace it
with one that has a hose barb; they are available at any good hardware
store. Then you can have a length of hose attached, and leave it in place,
running full-width behind the radiator and secured at the other end with a zip
tie. When you have to drain the system, you just hang the hose over your
drain pan and open it up. Here's a photo of mine in place:
http://www.poca.com/index.php/gallery/?g2_itemId=28741
Also, you know there are a pair of drain plugs located at the lowest point
in the engine block, right? One on each side. Pop those plugs out to
drain the back half of the system. Water might splash against the chassis
rails, but that's not the end of the world, especially if you've mostly drained
the system from the front already.
Cheers!
Mike
More information about the DeTomaso
mailing list