[DeTomaso] [detomaso]Pantera weight savings ideas

[richard bosch]

I like this idea versus the aluminum carriers as i think they would be lighter.If he is not around i do not think it would be that hard to fabricate them.Only difficult part if at all would be matching up the  od for the axle bearings and the lower shaft bushings.
--- On Mon, 11/19/12, Mark Tumbarello <ollerabmut at msn.com> wrote:

From: Mark Tumbarello <ollerabmut at msn.com>
Subject: RE: [DeTomaso] [detomaso]Pantera weight savings ideas
To: "richard bosch" <theemonkey at yahoo.com>, jjdetrich at gmail.com, "Detomaso at realbig.com" <detomaso at realbig.com>
Date: Monday, November 19, 2012, 8:04 PM





There was a guy in the Reno area, Ron Sipes I believe, that was fabricating sheet metal rear carriers. They were really a work of art, very light, and expensive.   Jack, is he still around?                     
> Date: Mon, 19 Nov 2012 19:27:35 -0800
> From: theemonkey at yahoo.com
> To: jjdetrich at gmail.com; detomaso at realbig.com
> Subject: Re: [DeTomaso] [detomaso]Pantera weight savings ideas
> 
> No one's suggested going on a diet. The result is the same and it doesn't
> cost a penny.
> Ha Ha,too true,but i only weigh 155 lbs.I joke with my friends that i am not skinny,i am race weight.Well i could lose 5 pounds...............: )
> _______________________________________________
> 
> Detomaso Forum Managed by POCA
> 
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
> 
> DeTomaso mailing list
> DeTomaso at realbig.com
> http://realbig.com/cgi-bin/mailman/listinfo/detomaso