[DeTomaso] Water temp gauge change with headlights
Thomas Tornblom
thomas at hax.se
Tue May 29 01:51:27 EDT 2012
I replaced the lamp sockets with ones that has a separate ground, so
that the ground for the illumination circuit does not go through the
gauges ground wires.
Thomas
2012-05-29 07:17, SOBill at aol.com skrev:
> Mike,
>
> The solution is run a separate ground wire from the temp gauge ground
> terminal directly to the chassis.
>
> The proper way to ground anything is the eliminate "daisy chained" grounds
> in which the ground current from one circuit can mix with the ground
> current from another circuit. But this takes a lot more wire and fabrication
> time. Each component should have it's own, separate ground to the chassis.
>
> Have fun today,
>
> sobill at aol.com
>
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
> !DSPAM:4fc45bfd141172219129925!
>
--
Real life: Thomas Törnblom Email: thomas at hax.se
Snail mail: Banvallsvägen 14 Phone: +46 18 32 31 18
S - 754 40 Uppsala, Sweden Mobile: +46 76 209 8320
More information about the DeTomaso
mailing list