[DeTomaso] Door adjustment

Rob Dumoulin rob at dumoulins.net
Mon May 28 13:20:31 EDT 2012


Take the door panel off and you will see 6 bolts (if I remember correctly)
connecting the door to the hinge. Don't loosen yet. Using a floor jack and
a block of wood, support the fully opened door weight. Not sure which
direction you mean be 'In', but with the door supported, you can loosen two
of the three top and tow of the three bottom bolts a little. Try to make an
adjustment by pulling/pushing on the door to move it horizontally or
raise/lower the jack for vertical. Tighten and test. Next adjustment,
loosen two of the three again, but this time loosen the one you didn't
before. With a little patience, you should be able to make it look perfect
and work after a few tries.

On Mon, May 28, 2012 at 12:50 PM, Nick McIntosh <threemacs at aol.com> wrote:

> Again after a recent paint job my door is out of adjustment.  It appears
> that the bottom of the door needs to come in maybe an eighth of an inch.
>  Also my locks don't want to work. How can I adjust the door and get the
> locks to work again?
>
> Sent from my iPad
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>



-- 
Rob DuMoulin
904.476.8744
rob at dumoulins.net



More information about the DeTomaso mailing list