[DeTomaso] MORE dipstick confusion???
thomas
thomas at hax.se
Wed May 2 23:13:40 EDT 2012
4 degrees is about 3.5 cm in height over a 50 cm distance, or in Mikesspeak, 1 3/8" over a 20" distance, even though I noticed that his tape measure was showing both cm and inches. ;)
Cheers,
Thomas
2 maj 2012 kl. 23:24 skrev B Hower <b.hower3400 at yahoo.com>:
> My DOAE Square Bore intake's carb. mounting surface is ~ 4 degrees --- low front.
>
> Bud #3400
>
>
> --- On Wed, 5/2/12, Thomas Tornblom <thomas at hax.se> wrote:
>
> From: Thomas Tornblom <thomas at hax.se>
> Subject: Re: [DeTomaso] MORE dipstick confusion???
> To: detomaso at realbig.com
> Date: Wednesday, May 2, 2012, 1:14 AM
>
> 2012-05-02 01:01, MikeLDrew at aol.com skrev:
> > Hi guys,
> >
> > Larry Finch was kind enough to mail me what is purportedly an original
> > standard Mustang 351C dipstick and tube. Although the tube and dipstick were
> > both a bit mangled, I was able to get them installed.
> >
> > Imagine my surprise when I discovered that the dipstick extended much
> > further into the oil pan than even the too-long Pantera dipstick????
> >
> > Check out all three side-by-side here:
> >
> > http://www.poca.com/index.php/gallery/?g2_itemId=36086
> >
> > Now I'm REALLY confused!
>
> Isn't this due to the tilted install in a Mustang? The front of the
> engine sits higher, which necessitates a longer dipstick to reach the
> oil level.
>
> So even the too-long Pantera dipstick appears to compensate slightly for
> the level install in a Pantera, but apparently not enough.
>
> Does anyone know the tilt angle of a standard Mustang engine?
>
> >
> > Mike
>
> Thomas
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
> !DSPAM:4fa1a66c565661443036!
More information about the DeTomaso
mailing list