[DeTomaso] MORE dipstick confusion???
B Hower
b.hower3400 at yahoo.com
Wed May 2 17:24:49 EDT 2012
My DOAE Square Bore intake's carb. mounting surface is ~ 4 degrees --- low front.
Bud #3400
--- On Wed, 5/2/12, Thomas Tornblom <thomas at hax.se> wrote:
From: Thomas Tornblom <thomas at hax.se>
Subject: Re: [DeTomaso] MORE dipstick confusion???
To: detomaso at realbig.com
Date: Wednesday, May 2, 2012, 1:14 AM
2012-05-02 01:01, MikeLDrew at aol.com skrev:
> Hi guys,
>
> Larry Finch was kind enough to mail me what is purportedly an original
> standard Mustang 351C dipstick and tube. Although the tube and dipstick were
> both a bit mangled, I was able to get them installed.
>
> Imagine my surprise when I discovered that the dipstick extended much
> further into the oil pan than even the too-long Pantera dipstick????
>
> Check out all three side-by-side here:
>
> http://www.poca.com/index.php/gallery/?g2_itemId=36086
>
> Now I'm REALLY confused!
Isn't this due to the tilted install in a Mustang? The front of the
engine sits higher, which necessitates a longer dipstick to reach the
oil level.
So even the too-long Pantera dipstick appears to compensate slightly for
the level install in a Pantera, but apparently not enough.
Does anyone know the tilt angle of a standard Mustang engine?
>
> Mike
Thomas
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list