[DeTomaso] Part # needed
Mike Thomas
mbefthomas at comcast.net
Wed May 2 08:43:44 EDT 2012
Should probably think about swapping out the pilot bushing if you haven't
already, since you're in there.
Mike Thomas
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of michael at michaelshortt.com
Sent: Tuesday, May 01, 2012 7:38 PM
To: DeTomaso Forum
Subject: [DeTomaso] Part # needed
My mechanic called today, and the steel flywheel surface area is warped on
the existing centerforce aluminum unit. A new one is over $600, but they
can put a new steel section in for only $85. - what a deal. Sent it off this
pm. Ordering new ARP bolts as well ($7) and I also need a throwout bearing.
Now the question, is there a specific unit for my Centerforce setup or can I
use a stock unit? No visible marks on the old unit. If so, any
recommendations or part numbers?
THANKS,
Michael Shortt
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list