[DeTomaso] Part # needed
Ken Green
kenn_green at yahoo.com
Tue May 1 23:57:40 EDT 2012
The reduced angular momentum of an aluminum flywheel may be is easier on the expensive synchros? I guess that assumes you drive the same way with the lighter flywheel.
Ken
From: Dave Londry <davel at emspace.com>
To: michael at michaelshortt.com
Cc: DeTomaso Forum <detomaso at realbig.com>
Sent: Tuesday, May 1, 2012 7:57 PM
Subject: Re: [DeTomaso] Part # needed
Mine's stock.
Doesn't mean it's right, but it works fine.
dave
On 01/05/2012 7:37 PM, michael at michaelshortt.com wrote:
> My mechanic called today, and the steel flywheel surface area is warped on
> the existing centerforce aluminum unit. A new one is over $600, but they
> can put a new steel section in for only $85. - what a deal. Sent it off
> this pm. Ordering new ARP bolts as well ($7) and I also need a throwout
> bearing.
>
> Now the question, is there a specific unit for my Centerforce setup or can
> I use a stock unit? No visible marks on the old unit. If so, any
> recommendations or part numbers?
>
> THANKS,
>
> Michael Shortt
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
>
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list