[DeTomaso] Which intake to use...
Will Kooiman
will.kooiman at gmail.com
Mon Jun 25 22:35:52 EDT 2012
Is that one of those mods that allows you to change jets w/out removing the fuel bowls?
If so, how do you like it?
On Jun 25, 2012, at 7:19 PM, MikeLDrew at aol.com wrote:
>
> In a message dated 6/25/12 17 05 14, asajay at asajay.com writes:
>
>
>> That's an interesting point Mike. Yes, the one I have has a
>> pronounced "tilt" to it. I had thought of using a simple wedge plate
>> to level it out instead of having it milled. Interesting you got it
>> all to fit under the stock screen. My present setup, just with the
>> Holley and a drop air cleaner from K&N, the screen fits tight.
>>
>> The Blue Thunder intake is quite a bit taller, so I don't think it
>> would fit. Just how much did they mill off yours?
>>
>
> Chris Difani milled it so that the back was the same height as the front.
> He basically milled the wedge out of it.
>
> I have a drop base air cleaner and a K&N filter. Curiously, fitting new
> engine mounts raised the engine just enough so that it no longer cleared the
> screen--I had to buy a new air cleaner assembly with a low-profile lid, then
> just use the lid with my existing drop base and air cleaner.
>
> I remember now that when I had the intake milled, it actually went a bit
> too far. The secondary accelerator pump arm bottomed out on the top of the
> intake runner. I had to fit an insulating spacer, perhaps 1/8 inch thick,
> to space the carb upwards just slightly to enable the accelerator pump to
> work.
>
> Here's a photo of the finished installation:
>
> http://www.poca.com/index.php/gallery/?g2_itemId=36426
>
> Mike
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list