[DeTomaso] Which intake to use...
MikeLDrew at aol.com
MikeLDrew at aol.com
Mon Jun 25 20:19:02 EDT 2012
In a message dated 6/25/12 17 05 14, asajay at asajay.com writes:
> That's an interesting point Mike. Yes, the one I have has a
> pronounced "tilt" to it. I had thought of using a simple wedge plate
> to level it out instead of having it milled. Interesting you got it
> all to fit under the stock screen. My present setup, just with the
> Holley and a drop air cleaner from K&N, the screen fits tight.
>
> The Blue Thunder intake is quite a bit taller, so I don't think it
> would fit. Just how much did they mill off yours?
>
Chris Difani milled it so that the back was the same height as the front.
He basically milled the wedge out of it.
I have a drop base air cleaner and a K&N filter. Curiously, fitting new
engine mounts raised the engine just enough so that it no longer cleared the
screen--I had to buy a new air cleaner assembly with a low-profile lid, then
just use the lid with my existing drop base and air cleaner.
I remember now that when I had the intake milled, it actually went a bit
too far. The secondary accelerator pump arm bottomed out on the top of the
intake runner. I had to fit an insulating spacer, perhaps 1/8 inch thick,
to space the carb upwards just slightly to enable the accelerator pump to
work.
Here's a photo of the finished installation:
http://www.poca.com/index.php/gallery/?g2_itemId=36426
Mike
More information about the DeTomaso
mailing list