[DeTomaso] Early Bumper Gasket source

[michael@michaelshortt.com]

You could also buy black plastic tubing like as used on a stethoscope,
slice it on one side and fit that over the edge of the bumpers, perhaps
securing with Black RTV.

Michael Shortt
On Jun 19, 2012 8:13 PM, "michael at michaelshortt.com" <michaelsavga at gmail.com>
wrote:

> http://pages.ebay.com/link/?nav=item.view&id=370615550735
> On Jun 19, 2012 8:11 PM, "michael at michaelshortt.com" <
> michaelsavga at gmail.com> wrote:
>
>> Have you tried black plastic Door Edge Guard and a heat gun?  Seems like
>> it would work with a little patience and a bottle of cold water with a
>> sprayer. Just fit it on, get to a bend area, heat it to the almost "melty"
>> stage, form it around the curvature,  spray it with cold water to set the
>> shape, then move on to the next straight or curved area.
>>
>> Michael Shortt
>> On Jun 19, 2012 7:56 PM, "Mark Charlton" <pantera01826 at rogers.com> wrote:
>>
>>> Hall sold their last sets "years ago" according to Tara. McMaster has
>>> nothing similar enough. Still searching..
>>>
>>> Thanks,
>>>
>>> Mark Charlton
>>> pantera01826 at rogers.com
>>>
>>>
>>>
>>> On Jun 16, 2012, at 12:11 PM, MikeLDrew at aol.com wrote:
>>>
>>> >
>>> > In a message dated 6/16/12 8 39 58, pantera01826 at rogers.com writes:
>>> >
>>> >
>>> >> Do any of you know where I can locate a very close match for the
>>> original bumper gaskets? I've already scoured the Trim-Lok and other
>>> catalogues on-line, but nothing seems quite right. Any help is much
>>> appreciated.
>>> >
>>> >
>>> > Hall Pantera was selling original bumper gaskets in the original Ford
>>> boxes on E-bay not long ago....?
>>> >
>>> > Mike
>>>
>>> _______________________________________________
>>>
>>> Detomaso Forum Managed by POCA
>>>
>>> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>>>
>>> DeTomaso mailing list
>>> DeTomaso at list.realbig.com
>>> http://list.realbig.com/mailman/listinfo/detomaso
>>>
>>