[DeTomaso] Heater to block connection
David D Fisher
fisher95020 at yahoo.com
Sun Jul 29 14:43:53 EDT 2012
Chance,
I really like this idea. Can you point me to where you picked up the fittings?
David
________________________________
From: Chance Dorsey <chance.dorsey at yahoo.com>
To: David <fisher95020 at yahoo.com>; "detomaso at realbig.com" <detomaso at realbig.com>
Sent: Sun, July 29, 2012 11:27:13 AM
Subject: Re: [DeTomaso] Heater to block connection
David,
I tapped mine with a 3/8 inch pipe tap.
Here's what it looks like now.
http://www.poca.com/gallery2/main.php?g2_itemId=36754
Later I'll add this stainless fitting for the heater hose.
http://www.poca.com/gallery2/main.php?g2_itemId=36757
Thanks,
Chance Dorsey
Austin, TX
From: David <fisher95020 at yahoo.com>
To: detomaso at realbig.com
Sent: Saturday, July 28, 2012 8:44 PM
Subject: [DeTomaso] Heater to block connection
Has anyone had success pressing a new heater hose (5/8 inch steel tube) into the
block with the engine in the car (Pantera). I'm looking for a better idea than
the one I have as there is no room to swing a hammer and the interference fit is
pretty darn tight. My best idea is to turn down the tube a little into I can
slide it in and use jb weld to seal it in place.
This really looks like a job for a press, but I expect most people use a hammer
when the block is out.
Thanks
David
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list