[DeTomaso] Best place to hook up a new circuit
Roger
coatesr8 at aol.com
Sun Jul 22 17:06:46 EDT 2012
Hi Again Charlie
Just now catching up on my mails, the instructions on mine did say connect DIRECT to battery via a fuse, my wire was also not long enough but you can extend it at the point of insertion of the fuse, I seem to recall my fuse is somewhere near the battery
Roger
Sent from Roger's iPhone
On 22 Jul 2012, at 18:56, SOBill at aol.com wrote:
> Ah, the *best* place.
>
> IMNSHO (In My Not So Humble Opinion)
>
> The best place is to connect the lamp power is the load terminal of the
> ammeter. The ammeter load terminal is the terminal with the big wire that
> doesn't go to the battery. This connection allows the alternator to provide
> the current to the lamps while maintaining correct functioning of the
> ammeter. For a picture of the ammeter terminals, see
> _http://www.panteraplace.com/Electrical/Ammeter%20Wiring.jpg_
> (http://www.panteraplace.com/Electrical/Ammeter%20Wiring.jpg)
>
> If you connect the lamp power to the battery, lamp current will indicate
> on the ammeter as a battery charging current when the alternator is
> supplying the load. If the alternator is not supplying the load, the drain on the
> battery due to the lamps will not be indicated on the ammeter.
>
> The actual lamp circuit should contain a relay which connects lamp power
> from the ammeter terminal when you want the lamps activated.
>
> Have fun today,
>
> _sobill at aol.com_ (mailto:sobill at aol.com)
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list