[DeTomaso] Pantera Parts Connection Rotors - opinions?
MikeLDrew at aol.com
MikeLDrew at aol.com
Tue Feb 14 19:46:17 EST 2012
In a message dated 2/14/12 15 30 41, bjbstewart at yahoo.com writes:
> I have talked with StopTech as well. Hub/Rotor one piece. :-(
>
While speaking with all these companies, it might be worthwhile to try to
explore if they DO have a rotor for some other application that would work?
Given that the bolt pattern is common to Dodge and Ford, I would think it
likely that an existing rear rotor for some other vehicle would easily be
adapted to the rear of the Pantera.
Pantera front and rear rotors are a different diameter, by the way--the
fronts are slightly smaller. Pat Orlando measured a couple for me and gave me
very rough measurements of 11 3/4 rear and 11 1/4 front. I've seen other
rotors measured at 297mm and 284mm, which is roughly the same. So although
Mustang rotors have been used on all four corners, I think there are some
fitment issues (I don't know if they're too big for the front or too small
for the rear).
It would take a lot of research, but I bet if somebody provided the
manufacturers with EXACT measurements of stock Pantera rotors, something would come
up that would work as a direct-fit replacement....
Mike
More information about the DeTomaso
mailing list