[DeTomaso] Steel vs aluminum flywheel
MikeLDrew at aol.com
MikeLDrew at aol.com
Wed Feb 8 18:51:43 EST 2012
In a message dated 2/8/12 12 40 9, kenn_green at yahoo.com writes:
> Unless Larry's engine was a low RPM build with a small carb, I don't
> think his experience applies to my plans.
>
It's a stroker with Aussie heads and a 700 cfm carb. Loads of bottom-end
response and torque, not a revver.
Unless your plans involve altering the laws of physics, his problems will
be your problems. :<(
Mike (watched one of Larry's clutches literally go up in smoke rounding a
15 mph hairpin uphill turn in 1st gear, right in front of me--explosion of
fiber particles and smoke out of the opening in the decklid, because he was
effectively having to drive in 3rd gear due to the ridiculous rear end
ratio...later I saw the flywheel, and it was completely blue from the excessive
heat due to the necessity to slip the clutch brutally ALL the time....)
More information about the DeTomaso
mailing list