[DeTomaso] Coil Packs
michael@michaelshortt.com
michaelsavga at gmail.com
Mon Aug 6 15:31:13 EDT 2012
On my race cars, we wrapped it 3 or 4 times in heat shrink tubing ( heating
it, then sliding another one on )
and added a couple of loops ( like a brake line ) to absorb the vibrations
for the reasons you describe.
Michael
On Mon, Aug 6, 2012 at 3:23 PM, <JDeRyke at aol.com> wrote:
> As a suggestion, Bill- the feed wire from the crank pickup has caused
> trouble for some in the past. Vibration and/or air blast flexes it and
> eventually
> metal fatigue happens under the insulation. Then the engine quits with no
> obvious cause. A big strain-relief support fixed one Electramotive unit,
> after 3 sensor replacements. Good luck- J Deryke
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
--
Michael L. Shortt
Savannah, Georgia
www.michaelshortt.com
michael at michaelshortt.com
912-232-9390
This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged. If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited. Please reply to the sender that you
have received this message in error, then delete it. Thank you
More information about the DeTomaso
mailing list