[DeTomaso] Dipstick photos and measurements // that's my final answer
Garth Rodericks
garth_rodericks at yahoo.com
Mon Apr 16 23:17:26 EDT 2012
I had my Weiand Xcelerator manifold milled level. I want to use the stock engine screen, so spacers were out of the question.
Pictures of milled intake 1/2 way down this page: http://www.banzairunnerpantera.com/adventures.htm
Cheers!
Garth
#4033
________________________________
From: "petersonmr06 at yahoo.com" <petersonmr06 at yahoo.com>
To: Garth Rodericks <garth_rodericks at yahoo.com>; DeTomaso Mail List <detomaso at realbig.com>; "Bill at incendium.com" <Bill at incendium.com>
Sent: Monday, April 16, 2012 6:51 PM
Subject: Re: [DeTomaso] Dipstick photos and measurements // that's my final answer
Jack D. set me straight years ago have a spacer milled to compensate
Sent via BlackBerry by AT&T
-----Original Message-----
From: Garth Rodericks <garth_rodericks at yahoo.com>
Sender: detomaso-bounces at realbig.com
Date: Mon, 16 Apr 2012 16:56:03
To: DeTomaso Mail List<detomaso at realbig.com>; Bill at incendium.com<Bill at incendium.com>
Reply-To: Garth Rodericks <garth_rodericks at yahoo.com>
Subject: [DeTomaso] Dipstick photos and measurements // that's my final
answer
>> "So the engine in a Pantera sits flat" (no tilt). Square with the world.
>> So is the carb now tilted and what effect would that have, just asking, here we go. >>
The 2 the come to mind immediately are:
1. Cannot set proper float levels
2. Engine dies under hard braking - excess fuel flows out the vent tube and down the carb throat choking the engine.
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list