[DeTomaso] Wheel Bearings GT5-S
JDeRyke at aol.com
JDeRyke at aol.com
Sun Apr 15 15:05:36 EDT 2012
In a message dated 4/14/12 12:46:55 PM, thomas at hax.se writes:
> The upright is not bored out on later cars, they are beefier from the
> start.
>
Thomas, I measured; however it was done, the larger bearing needs a bigger
hole and the usual cast relief inside between the two bearings is noearly
but not quite all, gone. If you weighed both an easrly & late bare upright and
the late one was heavier, OK.The simpest way is, it was bored. J Deryke
More information about the DeTomaso
mailing list