[DeTomaso] Apology to Mike Drew --- was Oil question at last resolved (I think)
Will Kooiman
will.kooiman at gmail.com
Fri Apr 13 17:56:42 EDT 2012
How could you measure the tube on the inside? The hole is much smaller than
my tape measure. ;-)
Actually, I think your method is about as accurate as you can get - i.e.
measure with masking tape, and then measure the tape.
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of MikeLDrew at aol.com
Sent: Friday, April 13, 2012 2:44 PM
To: b.hower3400 at yahoo.com
Cc: detomaso at realbig.com
Subject: Re: [DeTomaso] Apology to Mike Drew --- was Oil question at last
resolved (I think)
In a message dated 4/13/12 12 20 48, b.hower3400 at yahoo.com writes:
> Mike,
>
> I owe you an apology. How could I have even questioned your figures on
> the dipstick and tube in your Pantera? How naive can one be? I was in
error
> -- my steel tape must have gotten wet and shrunk!
>
> Bud #3400 ( red faced but not drunk)
>
>
No apology necessary!? I thought I made it clear that my measurement was
only approximate--it's difficult to do it properly. What I did was measure
the outside radius of the tube. If you measured along the inside, the
figure would likely be an inch shorter?
So, different people may come up with different figures based upon the
particularly methodology used. I need to pull the crank out of my spare
block
on Monday, so while I'm at it I'm going to set up a camera and shoot photos
to accompany measurements, so we'll all be on the same page at last. :>)
Mike
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list