[DeTomaso] Apology to Mike Drew --- was Oil question at last resolved (I think)
MikeLDrew at aol.com
MikeLDrew at aol.com
Fri Apr 13 15:43:36 EDT 2012
In a message dated 4/13/12 12 20 48, b.hower3400 at yahoo.com writes:
> Mike,
>
> I owe you an apology. How could I have even questioned your figures on
> the dipstick and tube in your Pantera? How naive can one be? I was in error
> -- my steel tape must have gotten wet and shrunk!
>
> Bud #3400 ( red faced but not drunk)
>
>
No apology necessary!? I thought I made it clear that my measurement was
only approximate--it's difficult to do it properly. What I did was measure
the outside radius of the tube. If you measured along the inside, the
figure would likely be an inch shorter?
So, different people may come up with different figures based upon the
particularly methodology used. I need to pull the crank out of my spare block
on Monday, so while I'm at it I'm going to set up a camera and shoot photos
to accompany measurements, so we'll all be on the same page at last. :>)
Mike
More information about the DeTomaso
mailing list