[DeTomaso] Wiper arms
JDeRyke at aol.com
JDeRyke at aol.com
Tue Sep 13 19:04:48 EDT 2011
In a message dated 9/13/11 12:47:40 PM, edlebby at yahoo.com writes:
snip.....
> these are a prototype (apparently) - there is an offset angle that is
> still off a bit, but supposedly won't effect them -
>
For years, I routinely bent the wiper arm ends to whatever angle I needed
for whatever car I was working on, using a Crescent wrench. Most of the arms
are stainless steel and slowly cold- bend without cracking. FWIW- J DeRyke
More information about the DeTomaso
mailing list