[DeTomaso] Coil Bracket

[gow2 at rc-tech.net]

That's a good idea but the metal is 3/8 thick. I could if I made it
thicker. Would be nice to do it out of aluminum.

G

> Very slick, why don't you countersink the holes and use allen heads in
> them
> to make it an invisible mount and tightening setup.
>
> Michael
>
>
>
>
>
> On Thu, Nov 3, 2011 at 4:28 PM, <gow2 at rc-tech.net> wrote:
>
>> Just thought I would pass on a photo of a coil bracket I made:
>>
>> http://www.rc-tech.net/cars2/mg2/coil.jpg
>>
>> Gary
>> _______________________________________________
>>
>> Detomaso Forum Managed by POCA
>>
>> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>>
>> DeTomaso mailing list
>> DeTomaso at list.realbig.com
>> http://list.realbig.com/mailman/listinfo/detomaso
>>
>
>
>
> --
>
>
>
>
>
>
>
> Michael L. Shortt
> Savannah, Georgia
> www.michaelshortt.com
> michael at michaelshortt.com
> 912-232-9390
>
>
> This email is protected by the Electronic Communications Privacy
> Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
> privileged.  If you are not the intended recipient, you are hereby
> notified
> that any retention, dissemination, distribution or copying of this
> communication is strictly prohibited.  Please reply to the sender that you
> have received this message in error, then delete it.  Thank you
>