[DeTomaso] Electromotive Ignition System

[michael@michaelshortt.com]

I remember those teeny tiny wires from back then, you're right.

We put foam between them back then, wrapped it in black tape and zip tied
that to anything we could.

Never had a problem, but the wires were small.

Michael





On Wed, Nov 2, 2011 at 2:14 PM, <JDeRyke at aol.com> wrote:

> 20 years ago they also used cheap pickup sensors with wires that had no
> strain relief so engine vibration cracked them on the road.  Check on this
> too... Good luck- J Deryke




-- 







Michael L. Shortt
Savannah, Georgia
www.michaelshortt.com
michael at michaelshortt.com
912-232-9390


This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged.  If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited.  Please reply to the sender that you
have received this message in error, then delete it.  Thank you