[DeTomaso] Electromotive-Thanks
Peter Kovacs
peter-kovacs at sbcglobal.net
Thu May 26 19:39:45 EDT 2011
Vroom. Stays running this time. Bad pin in the computer. Evan found it and fixed
it...and reflashed the program. Runs better now.
Thanks for the feedback and "stay tuned", no pun intended....well maybe.
Peter Kovacs
209 345-6708
209 436-2000 fx
________________________________
From: "JDeRyke at aol.com" <JDeRyke at aol.com>
To: peter-kovacs at sbcglobal.net; detomaso at realbig.com
Sent: Thu, May 26, 2011 10:22:52 AM
Subject: Re: [DeTomaso] Electromotive
In a message dated 5/26/11 8:41:52 AM, peter-kovacs at sbcglobal.net writes:
Is there anyone out here with real world experience with Electromotive
Ignitions? This is an older set up but the software is loaded, the equipment is
in place, but the 2 items are not communicating with each other....yet.
My experience via Joe Perrucci's older setup was, the wires going to the crank
pickup are small, sensitive and are not adequately strain-relieved. On one 1000
mile trip to 'Vegas & back, Joe lost THREE sensors. The sensor and especially
the wires need good debris shields and a strain relief loop. Good luck- J Deryke
More information about the DeTomaso
mailing list