[DeTomaso] Milodon Oil Pan Gaskets, and installing oil pan gaskets
Charles Engles
cengles at cox.net
Sun May 15 14:40:39 EDT 2011
Dear Dan,
That is the solution to doing that job with one less headache. In a
pinch a standard stud would get things aligned, but those special studs
would be the trick to have.
Warmest regards, Chuck Engles
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of Daniel C Jones
Sent: Sunday, May 15, 2011 11:04 AM
To: Pantera REALBIG forum
Subject: Re: [DeTomaso] Milodon Oil Pan Gaskets, and installing oil pan
gaskets
> Then comes the fun of sticking the new gasket UP against gravity and
> getting the holes aligned--and then placing the oil pan without knocking
> the gasket out of alignment----against gravity.
I have a set of special studs that I use on oil and transmission pans when
fighting gravity. They are tapered and spring loaded. Screw them in at
least the four corners and you can just push the pan into place and the
studs will hold the pan (and gasket) in place while you screw the bolts in
the rest of the holes. Then unscrew the studs and replace with bolts.
I inherited these so I'm not sure where one would buy a similar set.
Dan Jones
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list