[DeTomaso] Turn Signal & Hazard Switch woes
Julian Kift
julian_kift at hotmail.com
Thu May 5 10:53:37 EDT 2011
Thanks for all the advice, it turned out to be a combination of the junction block for the Hazard switch and the switch itself. I haven't totally cured it (new switch on order) but I do have turn signals again, just no hazards.
Julian
> From: jb841 at cox.net
> Date: Wed, 4 May 2011 08:52:05 -0700
> To: detomaso at realbig.com
> Subject: [DeTomaso] Turn Signal & Hazard Switch woes
>
> Julian,
>
> Make sure that the molex connector for the hazard switch is making a good connection
> and that the two halves are fully seated.
>
> Try a jumper from pin #31 on the turn signal flasher to ground.
>
> Make sure that the yellow and the yellow/black wires aren't reversed on the back of the
> hazard switch. Yellow to #49, yellow/black to #59d.
>
> John
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list