[DeTomaso] DeTomaso Digest, Vol 80, Issue 31-Hard Launches
Ken Green
kenn_green at yahoo.com
Thu Mar 31 18:30:40 EDT 2011
Richard,
I assume your problem was from having to slip the clutch a lot before completely releasing the clutch? I know a lot of Panteras have aluminum flywheels so it isn't always a problem. If your engine had a big cam etc. and didn't make much torque at very low RPM, it could be a bad combination on the street with an aluminum flywheel, unless you just rev up the motor and drop the clutch like Bob, LOL.
But I still think that if your car launches OK with an aluminum flywheel, it will be easier on the disk, especially at shifts. I'm putting a street engine together with an aluminum flywheel and EFI that should run real well just off idle. Hopefully I'll know soon.
Ken
--- On Thu, 3/31/11, richard at hitecheng.on.ca <richard at hitecheng.on.ca> wrote:
From: richard at hitecheng.on.ca <richard at hitecheng.on.ca>
Subject: Re: [DeTomaso] DeTomaso Digest, Vol 80, Issue 31-Hard Launches
To: "Ken Green" <kenn_green at yahoo.com>, detomaso at realbig.com, wdemelo at cogeco.ca, RCBSONS1 at aol.com
Date: Thursday, March 31, 2011, 2:26 PM
The aluminum flywheel does not have the mass of a steel flywheel and takes
more torque to get the car moving. It puts more stress on the drive train at
launch. I had one in my corvette with a 327. At launch it would almost stall
and burned up clutch disks. I contacted the manufacture who stated I needed
a heavier flywheel and sent me a billet steel flywheel for free with a new
disk.
Richard
-----Original Message-----
From: Ken Green
Sent: Thursday, March 31, 2011 5:11 PM
To: detomaso at realbig.com ; wdemelo at cogeco.ca ; RCBSONS1 at aol.com
Subject: Re: [DeTomaso] DeTomaso Digest, Vol 80, Issue 31-Hard Launches
The lower angular momentum of an aluminum flywheel should make it easier for
the engine RPM to adjust to the input shaft RPM and reduce wear on the
clutch disk.
I don't have any numbers on the angular momentum of the flywheel compared to
the rest of the engine. It must be somewhere, has anyone looked into it?
Ken
--- On Thu, 3/31/11, RCBSONS1 at aol.com <RCBSONS1 at aol.com> wrote:
From: RCBSONS1 at aol.com <RCBSONS1 at aol.com>
Subject: Re: [DeTomaso] DeTomaso Digest, Vol 80, Issue 31-Hard Launches
To: kenn_green at yahoo.com, detomaso at realbig.com, wdemelo at cogeco.ca
Date: Thursday, March 31, 2011, 1:42 PM
Alum flywheel for me
Bob Benson #3 Black Pantera
I actually worry about the clutch more than anything else
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list