[DeTomaso] Headlight door gear replacement
MikeLDrew at aol.com
MikeLDrew at aol.com
Sat Mar 26 02:54:43 EDT 2011
In a message dated 3/24/11 11 20 50, michaelsavga at gmail.com writes:
> Is their an existing DIY or how to on replacing / installing the bronze
> gear
> on the web?
>
It's exactly the same as the window gear, so the relevant articles at
www.panteraplace.com might be helpful.
It's only slightly more difficult than changing a lightbulb though. One
of the easier jobs you can do, I think. It's a bit of a PIA to get the
plate with the motor attached, out of the car--one of the limit switches needs
to be removed (4mm wrench required), then three 10mm bolts to remove the
plate, which drops down and back through the front fender opening.
Once the thing is on the bench, remove the cover, remove the gear, pay
careful attention to locate the very thin washers (actually bearings) that it
spins on, clean and regrease and install the new gear, and reinstall, paying
careful attention to ensure max engagement between the teeth of the motor and
the light bar gear.
Mike
More information about the DeTomaso
mailing list