[DeTomaso] Radiator Install Progress
Asa Jay Laughton
asajay at asajay.com
Wed Mar 16 11:06:32 EDT 2011
If you review some of the other photos in the same album, you should find some showing I used an off the shelf rubber gasket material usually used around car doors, trunk lids, etc. This gave me a great seal to the radiator.
Asa Jay
------Original Message------
From: JJD1010 at aol.com
Sender: detomaso-bounces at realbig.com
To: detomaso at realbig.com
Subject: Re: [DeTomaso] Radiator Install Progress
Sent: Mar 16, 2011 08:38
Asa Jay,
What do you use to fill the vertical space at both ends of the fan mount
cross bars to seal the fan shroud so that the fans don't suck air from the
back side of the radiator?
Jeff
6559
In a message dated 3/15/2011 9:47:36 P.M. Central Daylight Time,
asajay at asajay.com writes:
I've welded a couple of cross bars for mounting a flex-a-lite dual
sucker fan.
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
Sent using Elfen Magic.
More information about the DeTomaso
mailing list