[DeTomaso] 351C block needed in Germany
Julian Kift
julian_kift at hotmail.com
Thu Jun 16 12:55:52 EDT 2011
I was under the impression you cannot sleeve cylinders next to each other in a 351C as there's just not enough bore spacing, or is that a misconception on my part?
It can'tbe that expensive to get a bare block shipped from the US to Europe, surely?
Julian
> From: MikeLDrew at aol.com
> Date: Thu, 16 Jun 2011 12:40:29 -0400
> To: detomaso at realbig.com; r.bohner at gmx.de
> Subject: [DeTomaso] 351C block needed in Germany
>
> Hi guys,
>
> Roland Bohner, the fellow with the wild yellow turbo 351C Mangusta, has
> taken his engine apart (actually, it took itself apart on his way home after
> SpaItalia!). The block is shot--bored .030 over already, with a scratch in
> one bore, and all the holes are now oval instead of round.
>
> He is considering sleeving all eight cylinders because he can't find a
> rebuildable 351C block in Germany.
>
> Surely some of you Euro guys must have a line on a good block that he could
> use instead?
>
> Please 'reply all' with any possible solutions or words of advice, as he's
> not on the forum, but is CCed above.
>
> Thanks!
>
> Mike
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list