[DeTomaso] MSD distributor
SOBill at aol.com
SOBill at aol.com
Sun Jun 5 14:03:08 EDT 2011
If the coil is designed for 12V but is supplied via a ballast resistor or
ballast wire you could have this sort of problem.
Have fun today,
sobill at aol.com
In a message dated 6/5/2011 7:25:04 A.M. Pacific Daylight Time,
BillsStore at aol.com writes:
Installed a MSD drop-in distributor and initially had it hooked up to a
Mallory ignition system coil. It would run up to 5500 RPM then flat line
like it had a rev limiter. Slowly RPM backed down to 5000RPM Friend
gave me
a "old" MSD II coil to try. It is flat lining now at 4500 RPM. Have a
new
coil on order. If that fails, anyone have an idea what it could be?
Bill Vasser
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list