[DeTomaso] Front Cam Bearing

[Asa Jay Laughton]

Go here:
http://www.teampanteraracing.com/index.php?option=com_wrapper&view=wrapper&Itemid=74

Type "engine oil" without the quotes in the search box.  Data was as of 
about a year ago.

Asa Jay

Asa Jay Laughton, MSgt, USAFR, Retired
&  Shelley Marie
Spokane, WA
******************************
http://www.racingagainstautism.com
http://www.teampanteraracing.com


On 2/5/2011 16:40, wkooiman at earthlink.net wrote:
> The biggest issue with the front cam bearing is it exposes too much of the hole that oils the cam gear.  The consensus on the network54 forum is to install the #1 cam bearing as far forward as possible.  I don't think you can install it too far forward.  If you do, the retainer will just push it back.
>
> There is a really good thread on network54 that talks about all of the oiling mods.  You have to do what you feel comfortable doing.
>
> I did:
>
> 1.  #1 cam bearing as far forward as possible.
> 2.  Restrictors in mains 2-5.
> 3.  Restrictor under #1 cam bearing and plug under #1 main.
> 4.  Passage in rear of block enlarged to 1/2"
> 5.  Passage at rear of block opened to 3/8" pipe.  Stock is 1/4" pipe.
> 6.  -8 line from front to rear.
> 7.  Melling pump, Armando pan.
> 8.  Solid lifters (with solid lifter restrictor)
>
>
>
> -----Original Message-----
>> From: Chance Dorsey<chance.dorsey at yahoo.com>
>> Sent: Feb 4, 2011 12:05 PM
>> To: DetomasoList<detomaso at realbig.com>
>> Subject: [DeTomaso] Front Cam Bearing
>>
>>
>> I have a quick question about the location of the front cam bearing.  I measured the placement of the one in my block and the machine shop has installed it too deep.  Ford specifies that it be .003 - .005 from the face of the block.  I called the machinist to ask him about moving it forward a bit.  Of course, he said that it wasn't important as long as the bearing was not extended past the front of the block.  How did I know he was going to say that?
>>
>> Does the .003 to .005 space create a restriction to the amount of oil that goes between the bearing and the face of the thrust bearing?  Should I make the machine shop go ahead and move it?  I wanted to get a few more opinions other then just the one from the machinist.
>>
>> Thanks,
>>
>> Chance Dorsey
>> Austin, TX
>> _______________________________________________
>>
>> Detomaso Forum Managed by POCA
>>
>> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>>
>> DeTomaso mailing list
>> DeTomaso at list.realbig.com
>> http://list.realbig.com/mailman/listinfo/detomaso
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1204 / Virus Database: 1435/3425 - Release Date: 02/05/11
>
>