[DeTomaso] a few good bolts
JDeRyke at aol.com
JDeRyke at aol.com
Wed Dec 28 14:09:10 EST 2011
In a message dated 12/28/11 9:05:42 AM, b.hower3400 at yahoo.com writes:
> As to the bolt direction ------- I'm curious. It would seem that if a nut
> was to come off and the bolt was to back out, it would be better to not
> have it contact the ZF.
>
True; the preferred bolt placement seems to be more a matter of convenience
in holding the bolt head with an open end wrench while removing the nut
with a box-end wrench, than trying to do it the opposite way. The halfshafts
have spot-faced holes that a bolt head partially recesses into, so the
relatively thin bolt head sinks in. Gripping it with an open end wrench is hard;
a box-end normally won't clear halfshaft parts. And if the bolt shanks are a
tight fit in the parts, turning the bolt for removal is difficult even if
you do somehow get a good hold on the head. Tightening the assembly enough to
avoid vibrations under power is even more difficult. FWIW- J DeRyke
More information about the DeTomaso
mailing list