[DeTomaso] a few good bolts

[Dave Londry]

You won't want these ones that I just retired.
No shank and 0.435 major dia.
dave

On 27/12/2011 1:56 PM, Dave Londry wrote:
> I'll have a look now.
> dave
>
>
> On 27/12/2011 12:16 PM, B. Seib wrote:
>> Best wishes to all of you for health and happiness in 2012.
>>
>> I'm hoping to find at least 4 original bolts for the half shaft flange
>> connections.
>> A PO has lost 4 of mine.
>>
>> Perhaps someone has a few used ones left after replacing the complete set
>> with new ones?
>>
>> The originals were 7/16 x 20 x 1-1/4. The shank (unthreaded) portion
>> measures 0.4385" dia
>>
>> The new ones I bought from Aircraft Spruce are fine except the shank is only
>> 0.436" dia
>>
>> Because these act as drive pins, I'd really like to use originals if I can
>> find four of them.
>>
>> Thanks
>>
>> Barry
>>
>>
>> _______________________________________________
>>
>> Detomaso Forum Managed by POCA
>>
>> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>>
>> DeTomaso mailing list
>> DeTomaso at list.realbig.com
>> http://list.realbig.com/mailman/listinfo/detomaso
>>
>>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
>