[DeTomaso] Front Caliper Rebuild
Asa Jay Laughton
asajay at asajay.com
Tue Aug 30 17:43:34 EDT 2011
Some video of actual front caliper rebuilds can be seen here:
http://www.poca.com/index.php/pub/tech/65-chassis/214-stock-front-caliper-rebuild
It's far easier to put the pistons in first, after you put the o-ring
in the housing (not on the piston)
Then install the dust boot. The retaining ring goes on the housing
(not the piston), holding the outside edge. The groove in the piston
holds the boot at the piston. This allows the boot to flex and keep
out dust/dirt while the piston moves.
The video may help.
Asa Jay
Quoting Tipo874 at aol.com:
> I'm currently rebuilding a pair of front calipers, and not sure of the
> correct way to install the dust boots. First, is it correct (or easier) to
> put the boots and retaining rings on before you reinstall the
> pistons? Also,
> I seem to remember the retainers going on the outside of the piston when
> disassembling, but logic tells me fitting them in the groove would be more
> secure. Any guidance would be most appreciated.
> Thanks,
> Bob R. #3810, still drying out in NY
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
--
Asa Jay Laughton - sent from somewhere other than home
******************************************************
http://www.racingagainstautism.com
http://www.teampanteraracing.com
More information about the DeTomaso
mailing list