[DeTomaso] Alignment Specs.....revisited
John Buckman
jb841 at cox.net
Fri Aug 5 01:12:17 EDT 2011
Mike,
Do you know what the thickness is of the camber lock kit where it fits between the shim and the a-arm?
John
On Aug 4, 2011, at 9:07 PM, MikeLDrew at aol.com wrote:
>
> In a message dated 8/4/11 19 36 10, jb841 at cox.net writes:
>
>
>> A while back, I did mill .100" off of an old upper ball joint, just to see how it looked. As I
>> recall, it kind of left the boot overhanging into the the area that was removed. I need to
>> revisit this by drilling a hole into the ball joint (perpendicular to the milled face) just to see
>> how much "meat" is left.
>
>
> Perhaps you could try to go further than .100", but I wouldn't risk it with a good ball joint.
>
> Here's a photo I just took of my front suspension setup:
>
> http://www.poca.com/index.php/gallery/?g2_itemId=33035
>
> The rear (left in the photo) side of the ball joint is milled .100", and a home-made .100" shim was added on the front side to compensate. Note also the Pantera Performance Center camber lock kit, which works GREAT!
>
> Mike
More information about the DeTomaso
mailing list