[DeTomaso] Bulkhead reduction kit pics
Rob Dumoulin
rob at dumoulins.net
Tue Apr 19 08:13:51 EDT 2011
Yea, that would have worked, but like I said, it only took a few tries to
get it right without it. I'll add an awl to my tool roll for next time.
Thanks,
Rob
On Mon, Apr 18, 2011 at 10:14 PM, John Buckman <jb841 at cox.net> wrote:
> The worst part was
> getting the pulley bolt holes lined up
>
> Use a drift, small pin punch, or an awl. Insert it through one of the the
> water pump pulley bolt holes and one of
> the threaded holes in the pump flange. As you move the pulley upward to
> align the pilot on the pump flange
> with the center hole in the pulley, the threaded flange holes will end up
> in close alignment once the pulley is
> on the flange pilot. Then, minor adjustments can be made by moving the
> drift from side to side.
>
> John
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
--
Rob DuMoulin
904.476.8744
rob at dumoulins.net
More information about the DeTomaso
mailing list