[DeTomaso] SHIFT ROD CENTER SUPPORT

[John Taphorn]

Nice work Thomas.  How did you prepare the sliding shaft?

JT
----- Original Message ----- 
From: "Thomas Tornblom" <Thomas.Tornblom at hax.se>
To: <detomaso at realbig.com>
Sent: Saturday, April 02, 2011 3:42 AM
Subject: Re: [DeTomaso] SHIFT ROD CENTER SUPPORT


>I made one out of a rod end and added a teflon bushing:
>
> http://www.hax.se/trunion2.jpeg
> http://www.hax.se/trunion3.jpeg
> http://www.hax.se/trunion4.jpeg
> http://www.hax.se/trunion5.jpeg
> http://www.hax.se/trunion6.jpeg
>
> I have since these photos were taken removed the old bronze bushing on
> the rod ;)
>
> 2011-04-01 23:36, Anders Hellberg skrev:
>> Work Hall Pantera TRUNION BEARING / SHIFT ROD CENTER SUPPORT/FRAME 
>> (06009A)
>> well?
>>
>> Have some other vendor something similar?
>>
>>
>> Anders
>>
>
> Thomas
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso