[DeTomaso] Swirl Tank
John Taphorn
jtaphorn at kingwoodcable.com
Sat Oct 16 15:09:31 EDT 2010
I recommend that you update your cooling system. Get rid of the Swirl Tank.
Route the coolant exiting the pipe off the thermostat housing to the lower
pipe. Braze a fitting on the pipe exiting the thermostat housing to allow a
1/4" line to go into your overflow tank at a level higher than the exit from
the thermostat pipe. You will need to add a fitting toward the top of the
overflow tank to accept this line. This will allow the air to naturally
migrate to the tank.
Connect the outlet on the bottom of the overflow tank to one of the intake
fittings on your waterpump. This will be a 3/8" to 1/2" line.
Add a pressure cap of 12lbs or more to your previous overflow tank that is
now your fill tank.
You now not only have an updated less restrictive cooling system with your
pressure cap on the low pressure side of your coolant system, but, more
money in your pocket.
JT
----- Original Message -----
From: "Tony DiGiovanna" <tonydigi at optonline.net>
To: "'De Tomaso List'" <detomaso at realbig.com>
Sent: Saturday, October 16, 2010 1:39 PM
Subject: [DeTomaso] Swirl Tank
> My stock tank finally rusted thru. Any opinions on favorite stainless
> replacements?
>
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list