[DeTomaso] Asa Jay's 1985 built 351C Forensics part II
steven.liebenow at att.net
steven.liebenow at att.net
Tue Nov 30 20:24:06 EST 2010
AJ,
When you are finally done looking and taking pictures, use a razor blade and
clean off the land area between the cylinders. Using a good straight edge piece
of stock, lay it across the block, top to bottom, and then with conventional
feeler gauges (wide flat ones) check to see how much clearance you have in the
narrow land area out to the water jacket areas.
See what you get! A couple of thousandths may be somewhat
normal.......010-.015....BAD!!!! That's when you deck a block....
80K on that motor? WOW you abused the crap out of it to waste those rod
bearings!!!!!
Two things: 1) change your oil more often...... :) 2) synthetic
oil..........
Less garp in your new engine no matter which way you go!!!
Ciao!
Steve
PS: Quite the polish job on them there intake ports bubba!!!! Sweet!
More information about the DeTomaso
mailing list