[DeTomaso] Dropped floor pans
Asa Jay Laughton
asajay at asajay.com
Fri Nov 5 18:19:58 EDT 2010
If you're not talking about the cooling tubes..... I for one need a picture.
Asa jay
Quoting Rob Dumoulin <rob at dumoulins.net>:
> This is a tube steel member that goes down the length of the car. Not part
> of the floor pan.
>
> On Fri, Nov 5, 2010 at 5:55 PM, <MikeLDrew at aol.com> wrote:
>
>>
>> In a message dated 11/5/10 2:53:45 PM, rob at dumoulins.net writes:
>>
>>
>> I took measurements based on what Dan said and realized that there is a
>> major structural member that runs between where my seat mount holes are and
>> the where the floor pan meets the center console. I thought the pan would
>> just drop in and tie into the frame.. There is no way I'm going to cut the
>> frame. Is my drop pan ill conceived?
>>
>>
>> No, your fears are ill-founded, I believe. The Kirk Evans/Pantera East
>> dropped floor pans are HEAVY duty steel, and are almost assuredly stronger
>> than any floppy Italian structure you cut out to install them.
>>
>> Mike
>
>
>
>
> --
> Rob DuMoulin
> 904.476.8744
> rob at dumoulins.net
> _______________________________________________
>
> Detomaso Forum Managed by POCA
>
> Archive Search Engine Now Available at http://www.realbig.com/detomaso/
>
> DeTomaso mailing list
> DeTomaso at list.realbig.com
> http://list.realbig.com/mailman/listinfo/detomaso
>
--
Asa Jay Laughton - sent from somewhere other than home
******************************************************
http://www.racingagainstautism.com
http://www.teampanteraracing.com
More information about the DeTomaso
mailing list