[DeTomaso] Dropped floor pans
Rob Dumoulin
rob at dumoulins.net
Fri Nov 5 17:57:07 EDT 2010
This is a tube steel member that goes down the length of the car. Not part
of the floor pan.
On Fri, Nov 5, 2010 at 5:55 PM, <MikeLDrew at aol.com> wrote:
>
> In a message dated 11/5/10 2:53:45 PM, rob at dumoulins.net writes:
>
>
> I took measurements based on what Dan said and realized that there is a
> major structural member that runs between where my seat mount holes are and
> the where the floor pan meets the center console. I thought the pan would
> just drop in and tie into the frame.. There is no way I'm going to cut the
> frame. Is my drop pan ill conceived?
>
>
> No, your fears are ill-founded, I believe. The Kirk Evans/Pantera East
> dropped floor pans are HEAVY duty steel, and are almost assuredly stronger
> than any floppy Italian structure you cut out to install them.
>
> Mike
--
Rob DuMoulin
904.476.8744
rob at dumoulins.net
More information about the DeTomaso
mailing list