[DeTomaso] AN fastener sizing system

[Julian Kift]

Okay I think this is more what you are looking for; it explains the designations for specifying AN bolt sizing/shank length and there is a link to a Figure 2 about half way down that goes to a chart for grip/length.

 

http://www.zenithair.com/kit-data/ra/hardware.html

 

Julian
 


From: doug at silicondesigns.com
To: julian_kift at hotmail.com; detomaso at realbig.com
Subject: RE: [DeTomaso] AN fastener sizing system
Date: Thu, 27 May 2010 10:31:03 -0700




I know about the AN fitting sizes being in 16ths but what I want is the additional information about bolt length and thread pitch.  
I understand that an AN4 bolt is a 4/16" or 1/4" bolt but how is is overall length, shank length and thead pitch specified?  In other words, where is that a decoder for the AN dash numbering system?
 
Doug

-----Original Message-----
From: Julian Kift [mailto:julian_kift at hotmail.com]
Sent: Thursday, May 27, 2010 9:04 AM
To: doug at silicondesigns.com; De Tomaso List
Subject: RE: [DeTomaso] AN fastener sizing system

You mean like this http://www.gre6.com/ansize
 
Julian
 
> From: doug at silicondesigns.com
> To: detomaso at realbig.com
> Date: Thu, 27 May 2010 08:12:28 -0700
> Subject: [DeTomaso] AN fastener sizing system
> 
> Has anyone found an online explanation of how the Army/Navy fastener part
> numbers equate to fastener size and thread?
> 
> Doug Braun
> blue 73L #5505
 		 	   		  
_________________________________________________________________
The New Busy is not the too busy. Combine all your e-mail accounts with Hotmail.
http://www.windowslive.com/campaign/thenewbusy?tile=multiaccount&ocid=PID28326::T:WLMTAGL:ON:WL:en-US:WM_HMP:042010_4