[DeTomaso] machine ball joint to modify alignment
Tomas Gunnarsson
guson at home.se
Sun May 2 15:24:52 EDT 2010
Like Thomas said, the message I responded to said .01". Even .1" is around
half a degree and not worth the trouble IMO.
Tomas
-----Original Message-----
From: MikeLDrew at aol.com [mailto:MikeLDrew at aol.com]
Sent: den 2 maj 2010 20:35
To: guson at home.se; detomaso at realbig.com
Subject: Re: [DeTomaso] machine ball joint to modify alignment
In a message dated 5/2/10 8:49:15 AM, guson at home.se writes:
What's the point of moving the joint .01"? This equals a caster change
of
less than .1 degree. Thomas Tornblom was considering moving hos joint
.75".
That's about 3.5 degrees of caster change.
It's not .010", it's .100".
.750" is 3/4 of an inch which is huge. No way you can do that.
Mike
More information about the DeTomaso
mailing list