[DeTomaso] Next tool for the community toolchest?

[michael@michaelshortt.com]

I did know one person who was good at that......but she divorced me
  Michael

On Mar 4, 2010 8:48 PM, <wkooiman at earthlink.net> wrote:

I'd like a 6061-T6 replica of the inside door handles.

I'd like them to be thicker than stock, so they can be used w/out the chrome
trim.

I think they would look nice polished too.  Do you know anyone that is good
at polishing handles?

I don't think it would be too hard to make the handles, but the inside
splines might be difficult.

I've often wondered if it would be good job for a 3D profiler, 3D plastic
printer, fed into a CNC - or would the inside splines still be too
difficult?


-----Original Message-----
>From: Asa Jay Laughton <asajay at asajay.com>
>Sent: Mar 4, 2010 3:54 PM
>...