[DeTomaso] assembly lube use after minor imspection of an enginethat set for a year?
Larry - Ohio Time Corp
larry at ohiotimecorp.com
Fri Jun 4 09:37:09 EDT 2010
Hi Ken,
You most likely do not need to use the lube, but I would. It will not cause
any harm. You did nark the lifters to back in the same hole...right?
Larry (old motors are like old men, they need...) - Cleveland
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of Ken Green
Sent: Friday, June 04, 2010 12:40 AM
To: detomaso at realbig.com
Subject: [DeTomaso] assembly lube use after minor imspection of an
enginethat set for a year?
I have taken a good look inside a low miles Cleveland that set for over a
year. I pulled the cam out to find out what it is, and measure the lobes,
and am putting it all back together now. It has 1000+ miles on what appears
to be a good quality rebuild with some nice parts.
Do I need to use break in cam lube on the cam? It's a Comp Cams 292H
hydraulic lifter cam and is suppose to be 2500 to 6500 RPM.
Thanks,
Ken
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list