[DeTomaso] Rubber for Pantera gas tank cushion/insulation

[Tony DiGiovanna]

Also cleaned the exterior of the tank with power wire brush, primed and
painted.  Worth considering while you have it out.  Luckily, my tank
interior was spotless.

-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of JDeRyke at aol.com
Sent: Friday, July 30, 2010 2:38 PM
To: tonydigi at optonline.net; garth_rodericks at yahoo.com; detomaso at realbig.com
Subject: Re: [DeTomaso] Rubber for Pantera gas tank cushion/insulation

In a message dated 7/29/10 2:41:55 PM, tonydigi at optonline.net writes:

> I bought some rubber sheets, approx 1ft by 6 inch and approx 1/4 or 3/8 
> thick, at the hardware store that were intended as a self-adhesive
traction 
> pads for industrial step use.  They had a raised tread pattern in them.  I

> cut them to size for this use.  The tread pattern allows water to
> drain/evaporate from the contact area.
> 
Excellernt move! The stock stuff was firm foamed rubber and held splashed 
water against the unpainted stock tank, enough so some tanks rusted thru
from 
the outside-in. The bottom pad was also this type. Good luck- J DeRyke
_______________________________________________

Detomaso Forum Managed by POCA

Archive Search Engine Now Available at http://www.realbig.com/detomaso/

DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso