[DeTomaso] Rubber for Pantera gas tank cushion/insulation
JDeRyke at aol.com
JDeRyke at aol.com
Fri Jul 30 14:37:42 EDT 2010
In a message dated 7/29/10 2:41:55 PM, tonydigi at optonline.net writes:
> I bought some rubber sheets, approx 1ft by 6 inch and approx 1/4 or 3/8
> thick, at the hardware store that were intended as a self-adhesive traction
> pads for industrial step use. They had a raised tread pattern in them. I
> cut them to size for this use. The tread pattern allows water to
> drain/evaporate from the contact area.
>
Excellernt move! The stock stuff was firm foamed rubber and held splashed
water against the unpainted stock tank, enough so some tanks rusted thru from
the outside-in. The bottom pad was also this type. Good luck- J DeRyke
More information about the DeTomaso
mailing list