[DeTomaso] Need a lead for rubber exhaust hanger material for the Goose!
damaadams at aol.com
damaadams at aol.com
Sun Jul 25 15:08:21 EDT 2010
Steve,
You could probably use the stuff I bought to rebuild my motor mounts. It's nitrile rubber, used as an industrial vibration isolator, comes in 6"x6"x1/2" pieces and can be had at Grainger, McMaster Carr, etc. Easy to cut and drill and heat resistant.
?
Daryl
-----Original Message-----
From: steven.liebenow at att.net
To: mailing list detomaso <detomaso at realbig.com>
Sent: Sun, Jul 25, 2010 3:40 am
Subject: [DeTomaso] Need a lead for rubber exhaust hanger material for the Goose!
All,
I would like to find a source of solid rubber material suitable for fab'ing
exhaust hanger for my new stainless mufflers for the Goose! Must be 1" or 24mm
thick.
I tried the Pantera version, but it is too big center to center hole by about
1/2"....ass dragger muffler....not a good thing!
My prev hangers were 3/4" material but the thinness caused the chassis hangers
to distort when tightened down....not good. ...and they are cracking....time
for new.
The Goose uses two different lengths....so if I can find the right material,
will be cutting and drilling to fit......
I've searched a bazillion muffler sites etc....to no avail.
Thanks!!!
Steve
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list