[DeTomaso] lower support shaft
Will Kooiman
wkooiman at earthlink.net
Sun Jul 18 22:14:38 EDT 2010
Yes. MAP = Marion Perna = Pantera East.
I thought his website was www.mapenterprises.com, but that URL goes
somewhere else. If you do a google search on "pantera east website", you'll
see a discussion where they say his website is down.
-----Original Message-----
From: detomaso-bounces at realbig.com [mailto:detomaso-bounces at realbig.com] On
Behalf Of boyd casey
Sent: Sunday, July 18, 2010 6:40 PM
To: SOBill at aol.com
Cc: detomaso at realbig.com; tipo874a at msn.com
Subject: Re: [DeTomaso] lower support shaft
Is it Mario at pantera east?
Boyd
On Sun, Jul 18, 2010 at 7:12 PM, <SOBill at aol.com> wrote:
> *tipo874a,*
> **
> *The mystery deepens.*
> **
> *I have two recently purchased lower shafts from MAP. The shafts are
> threaded 5/8-18.*
> **
> *5/8 = 0.625 inches*
> *9/16 = .5625 inches*
> *14mm = 0.551 inches *
> **
> *Neither 14mm x 2.0 nor 14mm x 1.5 nuts will thread on a 9/16-12 or
> 9/16-18 bolt by hand.*
> **
> *A 5/8 bolt will go over a 14mm bolt without threading.*
> **
> *Have fun now,*
> **
> *SOBill Taylor
> sobill at aol.com
>
>
> *
>
_______________________________________________
Detomaso Forum Managed by POCA
Archive Search Engine Now Available at http://www.realbig.com/detomaso/
DeTomaso mailing list
DeTomaso at list.realbig.com
http://list.realbig.com/mailman/listinfo/detomaso
More information about the DeTomaso
mailing list